Key Features & Specs
- Capture more crop in rolling and uneven terrain with a total wing range of 45”
- Experience the best of both worlds with a flexible cutterbar on a hinged draper
- Easily cut all crops with a consistent reel-to-cutterbar distance and improved reel torque
- Reduce cutterbar loss with Grain Saver Draper Belts
- Width 50 ft.
Specifications
Dimensions
Overall operating depth | With dividers: 3.2 m 10.6 ft |
Platform length | 16.1 m 52.9 ft |
Draper belts
Width | Side belts: 6.7 m 21.9 ft Center belts: 200 cm 79 in. |
Center belt reverse | Base |
Belt depth | 100 cm 39.8 in. |
Cleat height | 19 mm 0.75 in. |
Speed control | Hydraulic from cab (side belts only) |
Feed drum
Feed drum fingers | Heavy-duty and round with breakaway notch and retainer Diameter: 16 mm 0.625 in. |
Diameter | 40.6 cm 16 in. |
Finger reach | 152 mm 6 in. |
Operating speed | Low speed: 200 rpm High speed: 240 rpm |
Center cleanout door | Base |
Drum/auger reverse | Base |
Number of fingers | 18 |
Auger finger platform | Triple chevron, retracting |
Header height sensing
Type | Electrohydraulic |
Header height sensing on the ground | Base |
Header height sensing off the ground | Base |
Key Specs
Cutterbar length | 15.3 m 50.1 ft |
Knife drive | Double-cut, dual-drive, shaft-driven cutterbar: 10.2 cm 4 in. |
Draper belts speed control | Hydraulic from cab (side belts only) |
Knife speed | X Series Combine: 520 cycles/min S-Series Combine: 490 cycles/min |
Pickup reel operating speeds | 8-70 rpm |
Pickup reel
Reel reverse | Base |
Diameter | 106.7 cm 42 in. |
Speed control | Hydraulic |
Reel resume | Base |
Reel lift | Off the cutterbar: 100.6 cm 39.6 in. |
Reel fore and aft | Fore of the cutterbar: 26.4 cm 10.4 in. |
Height control | Hydraulic |
Fingers | Nylon |
Operating speeds | 8-70 rpm |
Number of slats | Six bat poly |
Platform
Type | Hinged frame flexible cutterbar |
Top auger
Size | Diameter: 43.2 cm 17 in. |
Type | Optional: hydraulic drive 250-350 rpm |
Fingered augers | Optional |
Additional information
Date collected | 24 Mar 2021 |